Русский   |  العربية  |  España  |  English
+   Heat Shrink
+   Slip on & Cold Shrink
+   Silicone Rubber
+   EPDM Rubber
+   Others
Technology >Slip on & Cold Shrink
The key of cold shrink technology is moulding round a joint or termination under its own elasticity without the need for special tools or techniques.
Cold Shrink component in the form of a plastic coil has been placed over the joint or cable end, the inner spiral can be pulled out then the insulating tube contracts from its pre-stretched size and shrinks onto the cable, exerting permanent radial pressure for joint lifetime.

Slip on termination and joint is whole molded done in the factory, customers only need to push the termination or joint body to the prepared cable by the elasticity self-tensile force, then body will hold the cable tightly, accordingly reducing on-site time for instllation.

About Us  |  Supply & Demand  |  Career  | Joint Venture |  Contact Us Download Friendly Link
CopyRight © 2009 United Electric All Rights Reserved.   ICP:07052075